2026/02: HW Developer for Electronic Control Unit

2026/02: HW Developer for Electronic Control UnitFull-timeLegal Entity: Bosch Global Software Technologies Private LimitedCompany DescriptionBosch Global Software Technologies Private Limitedis a 100% owned subsidiary of Robert Bosch GmbH, one of the world's leading global supplier of technology and services, offering end-to-end Engineering, IT and Business Solutions. With over 27,000+ associates, it’s the largest software development center of Bosch, outside Germany, indicating that it is the Technology Powerhouse of Bosch in India with a global footprint and presence in the US, Europe and the Asia Pacific region.Job DescriptionHardware Design Engineer – LV/HV Power Electronics & InvertersRole SummaryResponsible for the end-to-end design and development of low-voltage and high-voltage power electronics hardware, including DC/DC converters and low-power inverter systems, covering analog/digital circuitry, simulations, PCB design support, testing, and compliance with automotive standards.Key ResponsibilitiesDesign analog and digital circuits using microcontrollers, op-amps, transistor families, and mixed-signal interfaces.Develop low-voltage DC/DC converters and high-voltage wide-input flyback converters (multiple outputs, isolation, transformer design, feedback).Design B6 bridge HV inverter (1200V) using SiC MOSFETs, gate drivers, HV filter protection, thermal design, PCB stack-up and insulation.Perform worst-case design calculations, derating, stress and power-loss analysis.Conduct PSpice/LTspice simulations (time-domain, frequency-domain, Monte Carlo).Create schematics in Zuken CR8000/OrCAD and support PCB layout (Allegro/PADS) with considerations for EMC, PCB stack-up, PCB track characteristics, and manufacturability.Capture/analyze customer requirements using IBM DOORS NG and follow ASPICE processes.Support hardware testing, debugging (Design of experiments), and validation.Ensure compliance with ISO 16750, ISO 7637, CISPR 25, ISO 11452, and reinforced insulation standards (12V/24V/400-800V).Required SkillsAnalog & mixed‑signal circuit design using MCUs, op‑amps, BJTs/MOSFETs, ADC/DAC interfaces, and standard communication interfaces (SPI, I²C, UART, CAN).Power electronics design experience with low‑voltage DC/DC converters and wide‑input isolated flyback converters, including magnetics, feedback, and multi‑output regulation.High‑voltage inverter design expertise (up to 1200 V) with SiC MOSFETs, isolated gate drivers, protection concepts, thermal design, and reinforced insulation.Strong analytical capability in worst‑case design, derating, stress analysis, and power‑loss/thermal calculations.Proficiency in circuit simulation using PSpice/LTspice for transient, AC (loop stability), and Monte‑Carlo/worst‑case analysis.Schematic design and PCB layout support using Zuken CR8000/OrCAD and Allegro/PADS, with focus on EMC, high‑voltage spacing, stack‑up, and manufacturability.Requirements engineering experience using IBM DOORS NG with adherence to ASPICE development and change‑management processes.Hands‑on hardware debugging and validation skills, including structured root cause analysis (DoE) and lab‑based troubleshooting.Knowledge of automotive standards and compliance, including ISO 16750, ISO 7637, CISPR 25, ISO 11452, and insulation requirements for 12 V/24 V/400–800 V systems.QualificationsElectronics (BE/ME)Additional Information> 6yrsBy clicking the link above or any third-party link within this posting, you are leaving this site and going to a third-party website where the third-party website's terms and privacy policy applyI'm interestedI'm interestedPrivacy NoticeImprint